DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance - Service Information (1 Of 2) >> Battery Cooling Filter >> Installation [12/2019 - ] >> Procedure

Installation [12/2019 - ]: Procedure

  1. INSTALL NO. 2 HV BATTERY INTAKE FILTER 
    1. Engage the 2 claws to temporarily install the No. 2 HV battery intake filter to the No. 1 HV battery intake cover.
    2. Engage the claw to install the No. 2 HV battery intake filter to the No. 1 HV battery intake cover.
  2. INSTALL NO. 1 HV BATTERY INTAKE COVER 
    1. Engage the 2 guides to temporarily install the No. 1 HV battery intake cover to the No. 3 hybrid battery intake duct.
    2. Engage the claw to install the No. 1 HV battery intake cover to the No. 3 hybrid battery intake duct.
  3. INSTALL REAR DOOR SCUFF PANEL LH 
    1. Engage the 2 guides to temporarily install the rear door scuff panel LH.
    2. Engage the 4 claws to install the rear door scuff panel LH.
  4. CLEAR DTC 

    HINT: 

    If the message "Maintenance Required for Traction Battery Cooling Parts See Owner's Manual" is displayed on the multi-information display, clean or replace the No. 1 HV battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.

    Refer to DTC CHECK / CLEAR [12/2019 - 11/2023] , or refer to DTC CHECK / CLEAR [11/2023 - ]

Diesel-Data.com