DTC B1417: Evaporator Temperature Circuit [12/2019 - 10/2022]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Air Conditioner > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Evap Temp Sensor (Rear)	Rear evaporator temp. sensor (No. 2 air conditioning harness assembly)	Min.: -29.70°C (-21.46°F) Max.: 59.55°C (139.19°F)	Actual evaporator (rear) temperature displayed	Rear evaporator temp. sensor (No. 2 air conditioning harness assembly) circuit malfunction When open circuit: -29.70°C (-21.46°F) When short circuit: 59.55°C (139.19°F)

   Body Electrical > Air Conditioner > Data List 

   Tester Display
   Evap Temp Sensor (Rear)

   OK

   The display is as specified in the normal condition column.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to  REMOVAL [12/2019 - 10/2022] 

Result: 

NG 

See step  2

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE REAR EVAPORATOR TEMP. SENSOR (NO. 2 AIR CONDITIONING HARNESS ASSEMBLY). Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  3

1. Disconnect the H65 air conditioning amplifier assembly connector.
2. Disconnect the M15 rear evaporator temp. sensor (No. 2 air conditioning harness assembly) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H65-11 (TEC) - M15-8 (+)	Always	Below 1 Ω
   H65-15 (SG-9) - M15-7 (-)	Always	Below 1 Ω
   H65-11 (TEC) or M15-8 (+) - Body ground	Always	10 kΩ or higher
   H65-15 (SG-9) or M15-7 (-) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to  REMOVAL [12/2019 - 10/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR