Installation [11/2023 - ]: Procedure
- INSTALL NO. 2 INSTRUMENT PANEL WIRE
- Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.NOTE:
- When connecting any airbag connector, take care not to damage the airbag wire harness.
- Be sure to only connect the connectors to each corresponding color.
HINT:
Refer to How to Connect or Disconnect Airbag Connector.
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [11/2023 - ]
- Connect the No. 2 instrument panel wire to the wire harness clamp.
- Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
- INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
- INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- CONNECT NO. 2 INSTRUMENT PANEL WIRE
- Check that the ignition switch is off.
- Check that the cable is disconnected from the negative (-) auxiliary battery terminal.WARNING:
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- Connect the No. 2 instrument panel wire.NOTE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
HINT:
Refer to How to Connect or Disconnect Airbag Connector.
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [11/2023 - ]
- INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET (w/ Manual (SOS) Switch)
Refer to INSTALLATION [10/2022 - ]



