Removal [10/2022 - 11/2023]: Procedure

PRECAUTION

WARNING:

Be sure to read Precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [12/2019 - 11/2023]

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

REMOVE BATTERY SERVICE HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 1

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

for T24A-FTS: Refer to PROCEDURE - Step 1

for A25A-FXS: Refer to PROCEDURE - Step 2

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2022 - 11/2023]

REMOVE HEADLIGHT ASSEMBLY LH (for LH Side)
Refer to REMOVAL [09/2020 - 11/2023]

SEPARATE WINDSHIELD WASHER JAR ASSEMBLY (for LH Side)

Remove the bolt.

Remove the 2 bolts, nut and separate the windshield washer jar assembly.

REMOVE FRONT AIRBAG SENSOR

Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Disconnect the connector from the front airbag sensor.
NOTE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

HINT:

Refer to How to Connect or Disconnect Airbag Connector.

Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [12/2019 - 11/2023]

Remove the bolt and disengage the claw to remove the front airbag sensor.