Installation [11/2023 - ]: Procedure

1. Check that the ignition switch is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   WARNING:

   Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Engage the claw and install the front airbag sensor with the bolt.

   Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

   NOTE:

   • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
   • When installing the front airbag sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
   • Make sure that the front airbag sensor claw is securely inserted into the body hole.
4. Connect the connector to the front airbag sensor.
   NOTE:

   When connecting any airbag connector, take care not to damage the airbag wire harness.

   HINT: 

   Refer to How to Connect or Disconnect Airbag Connector.

   Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [11/2023 - ]

5. Check that there is no looseness in the installed parts of the front airbag sensor.

for T24A-FTS: Refer to PROCEDURE - Step 4

for A25A-FXS: Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

1. Install the windshield washer jar assembly with the 2 bolts and nut.

   Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

2. Install the bolt.

Refer to INSTALLATION [09/2020 - ]

Refer to OPERATION CHECK [11/2023 - ]

HINT: 

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2023 - ]

for Panoramic View Monitor System: Refer to CALIBRATION [11/2023 - ]