Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear wheel alignment adjustment | for HV Model
|
|
Refer to UTILITY [11/2023 - ] |
for Gasoline Model
|
|
Refer to UTILITY [11/2023 - ] | |
| Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement) |
Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | Refer to CALIBRATION [10/2022 - ] |
| Parking assist ECU initialization | Panoramic View Monitor System | Refer to CALIBRATION [11/2023 - ] | |
w/ AFS:
|
Lighting System (EXT) (w/ AFS) | Refer to INITIALIZATION [11/2023 - ] | |
| Gas leak from exhaust system is repaired*1 | Perform Inspection After Repair |
|
for A25A-FXS: Refer to INITIALIZATION [10/2021 - ] for T24A-FTS: Refer to INITIALIZATION [10/2022 - ] |
*1: for RH Side
WARNING:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.