On-Vehicle Inspection [12/2019 - ]: Procedure
- INSPECT WIPER RELAY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the WIPER relay.
*a Component without harness connected
(WIPER Relay)
- Measure the resistance according to the value(s) in the table below.
