DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) >> Power Back Door Closer Switch >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

  1. INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH 
    1. Check the switch.
      GTY933385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 1 Power Back Door Control Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        5 - 2 Pressed (On) Below 1 Ω
        5 - 2 Not pressed (Off) 10 kΩ or higher

        If the result is not as specified, replace the No. 1 power back door control switch.

    2. Check the switch illumination.
      1. Apply auxiliary battery voltage to the switch connector and check that the No. 1 power back door control switch illuminates.

        OK

        Auxiliary Battery Connection Specified Condition
        Auxiliary battery positive (+) → Terminal 6
        Auxiliary battery negative (-) → Terminal 1        		 Illumination illuminates

        If the result is not as specified, replace the No. 1 power back door control switch.

Diesel-Data.com