Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during multiplex network door ECU removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Multiplex network door ECU* | Reset back door close position | Power Back Door System | Refer to INITIALIZATION [12/2019 - 11/2023] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Multiplex network door ECU* | Reset back door close position | Power Back Door System | Refer to INITIALIZATION [12/2019 - 11/2023] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
NOTE:
When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) must be registered, so be sure to make a note of the automatic open stop position.