Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Replacement of front bumper assembly*	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking Support Brake System	Refer to CALIBRATION [12/2019 - 11/2023]
Replacement of front bumper assembly*	Front television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [12/2019 - 10/2022]
Replacement or removal and installation of 2 or more parts: Front television camera assembly, radiator grille sub-assembly or front bumper assembly Rear television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [12/2019 - 10/2022]
Replacement of headlight ECU sub-assembly LH Replacement of headlight assembly LH	Synchronize the vehicle information Perform headlight ECU sub-assembly LH initialization	Lighting System (EXT) (w/ AFS)	Refer to INITIALIZATION [12/2019 - 11/2023]

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.