DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (A25A-FXS) - Service Information) >> Mass Air Flow Meter >> Installation [12/2019 - ] >> Procedure

Installation [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY 

    HINT: 

    Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

    Refer to INITIALIZATION [12/2019 - 10/2021] , or refer to INITIALIZATION [10/2021 - ]

    1. Install the mass air flow meter sub-assembly to the air cleaner cap sub-assembly with the 2 screws.
      NOTE:
      • If the mass air flow meter sub-assembly has been struck or dropped, replace it.
      • If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
      • Make sure that the O-ring is not cracked or moved out of place when installing the mass air flow meter sub-assembly.
    2. Connect the mass air flow meter sub-assembly connector.
  2. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

      Refer to INITIALIZATION [12/2019 - 10/2021] , or refer to INITIALIZATION [10/2021 - ]

Diesel-Data.com