Installation [12/2019 - 11/2023]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	O-ring Groove
   *b	Crankshaft Position Sensor Tip

   Perform this procedure only when reusing the crankshaft position sensor.

   1. Clean the O-ring groove of the crankshaft position sensor.
      NOTE:

      Make sure the O-ring groove is free of foreign matter.

   2. Install a new O-ring to the crankshaft position sensor.
      NOTE:

      Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.

   3. Check if the O-ring is twisted.

      HINT: 

      Check the entire circumference of the seam of the O-ring for twisting.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *1	O-ring
      *a	OK
      *b	NG
      *c	Seam

2. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
3. Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   NOTE:

   • If the crankshaft position sensor has been struck or dropped, replace it.
   • Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
4. Connect the crankshaft position sensor connector.

Refer to INSTALLATION [12/2019 - 10/2021] , or refer to INSTALLATION [10/2021 - ]