Removal [12/2019 - 10/2022]: Procedure

Refer to REMOVAL [12/2019 - 10/2022]

1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
   NOTE:

   • Using height adjustment attachments and plate lift attachments, keep the engine assembly horizontal.
   • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
   • Using an engine sling device and engine lift, secure the engine assembly before servicing.
2. Using SST, hold the crankshaft pulley assembly.
   • SST: 09213-54015 
   • SST: 09330-00021 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft pulley assembly.
   • SST: 09213-54015 
   • SST: 09330-00021 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 8 bolts and flywheel sub-assembly from the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Type A:
   1. Remove the No. 1 crankshaft position sensor plate.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Type B:
   1. Remove the No. 1 crankshaft position sensor plate.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a knife, cut off the lip of the rear engine oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape
   *b	Cut Position

2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
   NOTE:

   Be careful not to damage the crankshaft.