DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Fuel System (A25A-FXS) - Service Information (1 Of 2)) >> FUEL INJECTOR (for Direct Injection) >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY 
    NOTE:

    This inspection is for checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 1.34 to 1.64 Ω

      If the result is not as specified, replace the direct fuel injector assembly.

      GTY509104Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Direct Fuel Injector Assembly)
Diesel-Data.com