DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Fuel System (A25A-FXS) - Service Information (1 Of 2)) >> Fuel Main Valve >> Removal [11/2023 - ] >> Procedure

Removal [11/2023 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to REMOVAL [11/2023 - ]

  2. REMOVE FUEL PRESSURE REGULATOR HOLDER 
    1. Disengage the 2 claws and remove the fuel pressure regulator holder from the fuel suction tube with pump and gauge assembly.
      GTY880796Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FUEL MAIN VALVE ASSEMBLY 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.
      GTY894334Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:
      • Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and fuel suction tube with pump and gauge assembly.
      • Do not damage the fuel suction tube with pump and gauge assembly.
    2. Remove the O-ring from the fuel main valve assembly.
      GTY769198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 O-ring
      *a Mesh
      *b Mini-clip
      NOTE:

      Do not remove the mesh and mini-clip from the fuel main valve assembly.

Diesel-Data.com