Installation [12/2019 - ]: Procedure

1. Secure the front axle assembly in a vise using aluminum plates.
   NOTE:

   Do not overtighten the vise.

2. Install the front lower ball joint assembly to the front axle assembly with the nut.

   Torque: 133 N.m (1356 kgf/cm, 98 ft.lbf) 

   NOTE:

   • Do not apply lubricants to the ball joint stud taper and threads.
   • Remove any foreign matter from the contact surface of the steering knuckle and ball joint stud taper.
3. Install a new cotter pin.
   NOTE:

   Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

Refer to PROCEDURE - Step 2