DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System (Front) - Service Information >> Front Stabilizer Bar >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

  1. INSPECT FRONT STABILIZER LINK ASSEMBLY 
    1. Inspect the turning torque of the ball joint.
      GTY932079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Secure the front stabilizer link assembly in a vise using aluminum plates.
        NOTE:

        Do not overtighten the vise.

      2. Install the nut to the front stabilizer link assembly stud.
      3. Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

        Turning Torque

        0.05 to 1.96 N.m (0.6 to 19 kgf/cm, 0.5 to 17 in.lbf)

        HINT: 

        If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.

      4. Turn the stud to check that the stud does not catch and there is no play.

        HINT: 

        If the stud catches or there is play while turning, replace the front stabilizer link assembly with a new one.

    2. Inspect the dust cover.
      1. Check that the dust cover is not cracked and that there is no grease on it.

        HINT: 

        If the dust cover is cracked or there is grease on it, replace the front stabilizer link assembly with a new one.

Diesel-Data.com