Installation [12/2019 - 11/2023]: Procedure

1. Engage the 4 claws to install the battery state sensor assembly to the battery current sensor holder.
2. Engage the wire harness clamp.
3. Connect the battery state sensor assembly connector.
4. Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

5. Connect the No. 2 frame wire to the battery state sensor assembly with the nut.

   Torque: 7.6 N.m (77 kgf/cm, 67 in.lbf) 

   NOTE:

   When disconnecting the No. 2 frame wire, some systems need to be initialized after the No. 2 frame wire is reconnected.

   Refer to INITIALIZATION [12/2019 - 09/2020] , or refer to INITIALIZATION [09/2020 - 10/2021] , or refer to INITIALIZATION [10/2021 - 10/2022] , or refer to INITIALIZATION [10/2022 - 11/2023]

Refer to PROCEDURE - Step 3