Rear Wiper Motor Circuit [11/2023 - ]: Procedure

1. Perform the Active Test according to the display on the GTS.

   Body Electrical > Main Body > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Rear Wiper Operation	Function to operate the rear wiper motor assembly	OFF or ON	-

   Body Electrical > Main Body > Active Test 

   Tester Display
   Rear Wiper Operation

   OK

   Rear wiper motor assembly operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - ] 

Result: 

NG 

See step  2

1. Remove the rear wiper motor assembly.

   Refer to REMOVAL [12/2019 - ]

2. Inspect the rear wiper motor assembly.

   Refer to INSPECTION [12/2019 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE REAR WIPER MOTOR ASSEMBLY. Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  3

1. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   W4-4 (+B) - Body ground	Ignition switch ON	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   W4-5 (E) - Body Ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  5

1. Disconnect the H135 main body ECU (multiplex network body ECU) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   W4-3 (LS) - H135-11 (RWRY)	Always	Below 1 Ω
   W4-3 (LS) or H135-11 (RWRY) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [11/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR