Washer Motor Circuit [12/2019 - 11/2023]: Procedure

1. Perform the Active Test according to the display on the GTS.

   Body Electrical > Main Body > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Front Washer Relay	Function to operate the windshield washer motor and pump assembly (Front)	OFF or ON	-
   Rear Washer Relay	Function to operate the windshield washer motor and pump assembly (Rear)	OFF or ON	-

   Body Electrical > Main Body > Active Test 

   Tester Display
   Front Washer Relay

   Body Electrical > Main Body > Active Test 

   Tester Display
   Rear Washer Relay

   OK

   Windshield washer motor and pump assembly operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - ] 

Result: 

NG 

See step  2

1. Remove the windshield washer motor and pump assembly.

   Refer to REMOVAL [12/2019 - 09/2020] , or refer to REMOVAL [09/2020 - 11/2023]

2. Inspect the windshield washer motor and pump assembly.

   Refer to INSPECTION [12/2019 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY. Refer to  REMOVAL [12/2019 - 09/2020]  , or refer to  REMOVAL [09/2020 - 11/2023] 

Result: 

OK 

See step  3

1. Disconnect the A6 windshield wiper relay assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A6-6 (IGWS) - Body ground	Ignition switch ON	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A6-5 (EWS) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  5

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A6-1 (+WR) - A38-1 (B)	Always	Below 1 Ω
   A6-7 (-WR) - A38-2 (SW)	Always	Below 1 Ω
   A6-1 (+WR) or A38-1 (B) - Body ground	Always	10 kΩ or higher
   A6-7 (-WR) or A38-2 (SW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE WINDSHIELD WIPER RELAY ASSEMBLY. Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR