Wireless Charger Power Source Circuit [12/2019 - 10/2022]: Procedure

1. Disconnect the T9 mobile wireless charger cradle assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   T9-1 (PGND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   T9-6 (B+) - Body ground	Ignition switch off	11 to 14 V
   T9-5 (ACC) - Body ground	Ignition switch ACC	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - 10/2022]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR