Driver Identification Method cannot be Set [11/2023 - ]: Procedure

1. Check the problem symptoms.

   Result

   Result	Proceed to
   Assignment of settings cannot be performed using the electrical key transmitter sub-assembly.	A
   Assignment of settings cannot be performed using the Bluetooth device.	B

Result: 

B 

See step  4

Result: 

A 

See step  2

1. Check the smart key system (for Start Function).

   For HV Model: Refer to OPERATION CHECK [11/2023 - ]

   For Gasoline Model: Refer to OPERATION CHECK [11/2023 - ]

   OK

   Smart key system (for Start Function) is normal

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO SMART KEY SYSTEM (for Start Function) 

For HV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2023 - ]

For Gasoline Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2023 - ]

Result: 

OK 

See step  3

1. Temporarily replace the main body ECU (multiplex network body ECU) with a new one.

   Refer to REMOVAL [11/2023 - ]

2. Check if settings can be assigned again to an electrical key transmitter sub-assembly.

   OK

   All of the electrical key transmitter sub-assemblies could be registered to the new certification ECU (smart key ECU assembly) successfully.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE) 

Result: 

NG 

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY 

Refer to REMOVAL [11/2023 - ]

1. Check if settings can be assigned again to an electrical key transmitter sub-assembly.

   OK

   Settings can be assigned

   Result

   Proceed to
   OK
   NG

Result: 

OK 

GO TO AUDIO AND VISUAL SYSTEM (PROBLEM SYMPTOMS TABLE) 

Refer to PROBLEM SYMPTOMS TABLE [10/2022 - 11/2024] , or refer to PROBLEM SYMPTOMS TABLE [11/2024 - ]

Result: 

NG 

See step  2