DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Smart Key System (For Start, Except HV) - Diagnostic Codes (1 Of 2) >> SMART KEY SYSTEM (for Start Function, Gasoline Model) >> DTC B2286: Runnable Signal Malfunction; DTC B228A: Engine Speed Signal Circuit; DTC P0335: Crankshaft Position Sensor Circuit Malfunction (NE Signal) [10/2021 - 10/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

NOTE:
  • When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  • The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2021 - 11/2023]

  • Inspect the fuses of circuits related to this system before performing the following procedure.
  • Before replacing the certification ECU (smart key ECU assembly), refer to Registration.

    Refer to REGISTRATION [10/2021 - 10/2022]

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

HINT: 

When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

Diesel-Data.com