Caution / Notice / Hint

NOTE:

When using the GTS with the ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Key. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2021]
Before replacing the steering lock ECU (steering lock actuator or upper bracket assembly), refer to Registration.
Refer to REGISTRATION [12/2019 - 10/2021]
After performing repairs, confirm that no DTCs are output again.
Refer to DTC CHECK / CLEAR [12/2019 - 10/2021]

HINT:

When all the ECUs that are connected via LIN communication cannot communicate with the certification ECU (smart key ECU assembly), DTC B2785 is stored.