DCM Data Signal Circuit between Radio Receiver and DCM [10/2022 - ]: Procedure

1. Disconnect the H11 and c7 DCM (telematics transceiver) connector.
2. Disconnect the H108 and c6 radio and display receiver assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H11-15 (USBV) - H108-18 (USBV)	Always	Below 1 Ω
   H11-31 (USBG) - H108-17 (USBG)	Always	Below 1 Ω
   H11-17 (VOT+) - H108-15 (VOR+)	Always	Below 1 Ω
   H11-33 (VOT-) - H108-16 (VOR-)	Always	Below 1 Ω
   c7-1 (US4+) - c6-2 (USB+)	Always	Below 1 Ω
   c7-2 (US4-) - c6-1 (USB-)	Always	Below 1 Ω
   c7-3 (UGD4) - c6-3 (USBS)	Always	Below 1 Ω
   H11-15 (USBV) or H108-18 (USBV) - Body ground	Always	10 kΩ or higher
   H11-31 (USBG) or H108-17 (USBG) - Body ground	Always	10 kΩ or higher
   H11-17 (VOT+) or H108-15 (VOR+) - Body ground	Always	10 kΩ or higher
   H11-33 (VOT-) or H108-16 (VOR-) - Body ground	Always	10 kΩ or higher
   H108-4 (SGND) - Body ground	Always	10 kΩ or higher
   c7-1 (US4+) or c6-2 (USB+) - Body ground	Always	10 kΩ or higher
   c7-2 (US4-) or c6-1 (USB-) - Body ground	Always	10 kΩ or higher
   c7-3 (UGD4) or c6-3 (USBS) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR