DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Smart Key System (For Start, HV) - Diagnostic Codes (1 Of 2)) >> SMART KEY SYSTEM (for Start Function, HV Model) >> DTC B2285-62: Steering Lock Position Signal Compare Failure [11/2023 - ] >> Description

DTC B2285-62: Steering Lock Position Signal Compare Failure [11/2023 - ]: Description

WARNING: This page is about a different variant/trim than selected.

This DTC is stored when there is no continuity between terminal SLP of the certification ECU (smart key ECU assembly) and ground.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2285-62 Steering Lock Position Signal Compare Failure This DTC is stored when there is no continuity between terminal SLP of the certification ECU (smart key ECU assembly) and ground.
  • Certification ECU (smart key ECU assembly)
  • Wire harness or connector
 DTC Output Confirmation Operation: 
  1. Disconnect the cable from the negative (-) auxiliary battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) auxiliary battery terminal. Wait at least 40 seconds with the ignition switch off, then turn the ignition switch to ON and wait at least 40 seconds.
VEHICLE CONDITION AND FAIL-SAFE FUNCTION WHEN MALFUNCTION DETECTED

Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The hybrid control system cannot be started. The ECU does not send a hybrid control system start request.
RELATED DATA LIST AND ACTIVE TEST ITEMS

DTC No. Data List and Active Test
B2285-62 -
Diesel-Data.com