Caution / Notice / Hint
NOTE:
- Before replacing the engine stop and start ECU, read the number of starter operations and write it into a new engine stop and start ECU.
Refer to REGISTRATION [12/2019 - 10/2022]
- After replacing the engine stop and start ECU or air conditioning amplifier assembly, reset and perform learning of the air conditioning information in the engine stop and start ECU.
Refer to REGISTRATION [12/2019 - 10/2022]
- After replacing the engine stop and start ECU or airbag sensor assembly, clear and calibrate the deceleration sensor zero point in the engine stop and start ECU.
Refer to REGISTRATION [12/2019 - 10/2022]
- When the engine stop and start ECU or oil pump with solenoid assembly is replaced, check the oil pump with solenoid assembly.
Refer to REGISTRATION [12/2019 - 10/2022]
- After replacing the engine stop and start ECU assembly, perform learning of the external backup boost converter (eco run vehicle converter assembly).
Refer to REGISTRATION [12/2019 - 10/2022]
- Inspect the fuses for circuits related to this system before performing the following procedure.
HINT:
- If electrical load from additional devices installed to the vehicle (aftermarket audio system, etc.) is applied to the B41, B42, B43, IG41 or EMOP terminal in the engine stop and start ECU, the fuse function of the backup boost converter may operate.
If the fuse function of the backup boost converter operates, any systems connected to the B41, B42, B43, IG41 or EMOP terminal in the engine stop and start ECU will not operate.
- If DTCs P2796-12 (Electromagnetic Oil Pump Circuit Short to Battery), P2796-14 (Electromagnetic Oil Pump Circuit Open), P2797-96 (Electromagnetic Oil Pump Component Internal Failure) and P323A-19 (Backup Boost Converter "A" Circuit Current Above Threshold) are output simultaneously, troubleshoot for DTC P2796-12, P2796-14 or P2797-96 first, as a malfunction which causes DTC P2796-12, P2796-14 or P2797-96 to be stored may also cause DTC P323A-19 to be stored.
- DTCs for the stop and start system are not cleared even if the malfunction has been repaired. After repairing the malfunction, be sure to clear the DTCs.
- Using the GTS, read the Freeze Frame Data before troubleshooting. System condition information is recorded as Freeze Frame Data the moment a DTC is stored. This information can be useful when troubleshooting.