Caution / Notice / Hint

NOTE:

After replacing the starter assembly, perform initialization of the number of starter operations stored in the engine stop and start ECU.
Refer to REGISTRATION [10/2022 - 11/2023]
After replacing the engine stop and start ECU or airbag ECU assembly, clear and calibrate the deceleration sensor zero point in the engine stop and start ECU.
Refer to REGISTRATION [10/2022 - 11/2023]
After replacing the engine stop and start ECU assembly, perform learning of the external backup boost converter (eco run vehicle converter assembly).
Refer to REGISTRATION [10/2022 - 11/2023]
When the engine stop and start ECU or oil pump with solenoid assembly is replaced, check the oil pump with solenoid assembly.
Refer to REGISTRATION [10/2022 - 11/2023]
Before replacing the engine stop and start ECU, read the number of starter operations, total number of engine starts and write it into a new engine stop and start ECU.
Refer to REGISTRATION [10/2022 - 11/2023]
When the starter assembly is replaced, "ST relay" must be also replaced.
Inspect the fuses for circuits related to this system before performing the following procedure.
After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to INITIALIZATION [10/2022 - 11/2023]