Caution / Notice / Hint
NOTE:
- After replacing the starter assembly, perform initialization of the number of starter operations stored in the engine stop and start ECU.
Refer to REGISTRATION [11/2023 - ]
- After replacing the engine stop and start ECU or airbag ECU assembly, clear and calibrate the deceleration sensor zero point in the engine stop and start ECU.
Refer to REGISTRATION [11/2023 - ]
- After replacing the engine stop and start ECU assembly, perform learning of the external backup boost converter (eco run vehicle converter assembly).
Refer to REGISTRATION [11/2023 - ]
- When the engine stop and start ECU or oil pump with solenoid assembly is replaced, check the oil pump with solenoid assembly.
Refer to REGISTRATION [11/2023 - ]
- Before replacing the engine stop and start ECU, read the number of starter operations, total number of engine starts and write it into a new engine stop and start ECU.
Refer to REGISTRATION [11/2023 - ]
- When the starter assembly is replaced, "ST relay" must be also replaced.
- Inspect the fuses for circuits related to this system before performing the following procedure.