DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> CXPI Communication System - Diagnostics - Introduction >> CXPI Communication System >> Precaution [11/2023 - ] >> Precaution [11/2023 - ]

Precaution [11/2023 - ]

  1. PRECAUTION FOR POWER DISTRIBUTION BOX ASSEMBLY 
    1. Do not remove or install the power distribution box assembly with the negative (-) auxiliary battery terminal connected.
      NOTE:

      After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

      Refer to BEFORE DISCONNECTING BATTERY [11/2023 - ]

      HINT: 

      When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

      Refer to AUTOMATIC LEARNING CHART [11/2023 - ]

    2. Make sure that the power distribution box assembly is not exposed to water, as it is not waterproof.
    3. Some loads are connected to circuits with dedicated overcurrent protection. Therefore, do not use parts other than those specified for the vehicle.
    4. When replacing the power distribution box assembly, the system may not operate normally if the same part number is not used.
    5. Check that systems are operating normally before proceeding with troubleshooting.
Diesel-Data.com