DTC P1366-29: "E" Camshaft Position Actuator Bank 1 Signal Invalid [12/2019 - 10/2022]: Procedure

1. Disconnect the cam timing control motor with EDU assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C20-4 (VTM) - C55-72 (EMD1)	Always	Below 1 Ω
   C20-4 (VTM) or C55-72 (EMD1) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

Refer to REMOVAL [12/2019 - 10/2022]

HINT: 

Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.

Refer to INITIALIZATION [12/2019 - 10/2021] , or refer to INITIALIZATION [10/2021 - ]

Result

Result: 

NEXT 

See step  3

1. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

2. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
2. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P1366-29 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE ECM 

Refer to REMOVAL [12/2019 - 10/2022]