DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System - Service Information >> Millimeter Wave Radar Sensor >> Installation [12/2019 - 09/2020] >> Procedure

Installation [12/2019 - 09/2020]: Procedure

  1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY 
    NOTE:

    If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

    1. Engage the 2 guides.
      Fig 1: Millimeter Wave Radar Sensor Assembly Bolts And Screw Tightening Sequence
      GTY861583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Screw
    2. Install the millimeter wave radar sensor assembly with the 2 bolts and screw.

      Bolt 

      Torque: 2.5 N.m (25 kgf/cm, 22 in.lbf) 

      HINT: 

      Tighten the bolts and screw in the order shown in the illustration.

    3. Connect the connector.
  2. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  3. ADJUST MILLIMETER WAVE RADAR SENSOR 
    1. When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

      Refer to ADJUSTMENT [12/2019 - 09/2020] 

Diesel-Data.com