Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
P0201, P0202, P0203 AND P0204
| All of the following conditions are met | - |
| Confirmed injection | 2 times or more |
| Either of the following conditions is met | A or B |
| A. All of the following conditions are met | (a), (b) and (c) |
| (a) Starter | Off |
| (b) Auxiliary battery voltage | 10.5 V or higher |
| (c) Time after condition (b) is met | 0.5 seconds or more |
| B. All of the following conditions are met | (d), (e) and (f) |
| (d) Starter | On |
| (e) Auxiliary battery voltage | 8 V or higher |
| (f) Time after condition (e) is met | 0.5 seconds or more |
| Engine speed | 100 to 6000 rpm |
| Injection time | 0.00023 seconds or more |
| Injector driver relay | On |
| Fuel injector driver performance fail (P062D) | Not detected |
| The other injector of the same INJECTOR DRIVER FAIL SIGNAL | Not operating |
| Ignition switch | ON |
| Time after ignition switch off to ON | 0.5 seconds or more |
P062D
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Confirmed injection | 2 times or more |
| Either of the following conditions is met | A or B |
| A. All of the following conditions are met | (a), (b) and (c) |
| (a) Starter | Off |
| (b) Auxiliary battery voltage | 10.5 V or higher |
| (c) Time after condition (b) is met | 0.5 seconds or more |
| B. All of the following conditions are met | (d), (e) and (f) |
| (d) Starter | On |
| (e) Auxiliary battery voltage | 8 V or higher |
| (f) Time after condition (e) is met | 0.5 seconds or more |
| Engine speed | 100 to 6000 rpm |
| Injection time | 0.00023 seconds or more |
| Injector driver relay | On |
| The other injector of the same INJECTOR DRIVER FAIL SIGNAL | Not operating |
| Ignition switch | ON |
| Time after ignition switch off to ON | 0.5 seconds or more |