DTC P0013-13: Camshaft Position "B" - Actuator Bank 1 Circuit Open [12/2019 - 10/2022]: Procedure

1. Clear the DTC after recording the Freeze Frame Data and DTC.

   Powertrain > Engine > Clear DTCs 

2. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Put the engine in Inspection Mode (Maintenance Mode).

   Powertrain > Hybrid Control > Utility 

   Tester Display
   Inspection Mode

2. Start the engine.
3. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P0013-13 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [12/2019 - ]

Result: 

B 

See step  3

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 

Refer to REMOVAL [12/2019 - ]

Result: 

OK 

See step  4

1. Disconnect the cam timing oil control solenoid assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C25-2 (+) - C55-26 (OE1+)	Always	Below 1 Ω
   C25-1 (-) - C55-25 (OE1-)	Always	Below 1 Ω
   C25-2 (+) or C55-26 (OE1+) - Body ground and other terminals	Always	10 kΩ or higher
   C25-1 (-) or C55-25 (OE1-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM 

Refer to REMOVAL [12/2019 - 10/2022]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR