DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> TOYOTA Multi Operation Touch System - Diagnostics - Introduction >> TOYOTA Multi Operation Touch System >> Data List / Active Test [12/2019 - 10/2022] >> Data List / Active Test [12/2019 - 10/2022]

Data List / Active Test [12/2019 - 10/2022]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the GTS on.
    4. Enter the following menus: Body Electrical / D-SEAT SW / Data List.
    5. Read the Data List according to the display on the GTS.

      Body Electrical > D-SEAT SW > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Number of Trouble Codes Number of stored DTCs min.: 0, max.: 255 Number of DTCs will be displayed -
Diesel-Data.com