DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (12.3 Inch Display) Symptom Tests & Circuit Tests >> NAVIGATION SYSTEM (for 12.3 Inch Display) >> Radio Receiver Power Source Circuit [12/2019 - 10/2022] >> Procedure

Radio Receiver Power Source Circuit [12/2019 - 10/2022]: Procedure

  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE) 
    1. Disconnect the H4 and H5 radio receiver assembly connectors.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      H4-1 (GND1) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      H4-4 (+B1) - H4-1 (GND1)*1 Ignition switch off 11 to 14 V
      H4-4 (+B1) - H4-1 (GND1)*2 Always 11 to 14 V*3
      10.5 to 16 V*4
      H4-15 (ACC1) - H4-1 (GND1) Ignition switch ACC 11 to 14 V*3
      10.5 to 16 V*4
      H5-19 (IG) - H4-1 (GND1) Ignition switch ON 11 to 14 V
      1. *1: for HV Model
      2. *2: for Gasoline Model
      3. *3: w/o Stop and Start System
      4. *4: w/ Stop and Start System

      Result

      Result Proceed to
      OK A
      NG (w/o Stop and Start System) B
      NG (w/ Stop and Start System) C

    Result: 

    A 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - 10/2022] 

    Result: 

    B 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    C 

    GO TO STOP AND START SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2022] 

Diesel-Data.com