Reverse Signal Circuit [12/2019 - 10/2022]: Procedure

1. Move the shift lever to R and check if the back-up lights come on.

   OK

   The back-up lights come on.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO LIGHTING SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 11/2023] 

Result: 

OK 

See step  2

1. Disconnect the H1 radio and display receiver assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H1-28 (REV) - Body ground	Ignition switch ON Shift lever in R	11 to 14 V
   H1-28 (REV) - Body ground	Ignition switch ON Shift lever not in R	Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - 10/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR