Confirmation Driving Pattern

HINT: 

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

  Refer to UTILITY [12/2019 - 11/2023]

• When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.

  Refer to DTC CHECK / CLEAR [12/2019 - 11/2023]

1. Connect the GTS to the DLC3.
2. Turn the ignition switch to ON and turn the GTS on.
3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
4. Turn the ignition switch off and wait for 2 minutes or more.
5. Turn the ignition switch to ON and turn the GTS on.
6. Turn the ignition switch to ON (READY). [*1]
7. With the shift lever in D, depress both the accelerator pedal and brake pedal at the same time to raise the "Hybrid Battery SOC" to a sufficient level. [*2]
8. Move the shift lever to P, check that the engine is stopped and move the shift lever to N. [*3]
9. Set the A/C for maximum cooling. [*4]
10. Leave the vehicle for a few minutes. [*5]

    HINT: 

    • After the repair if "VL-Voltage before Boosting" and the "Hybrid Battery Voltage" are approximately the same when the ignition switch is turned to ON (READY) with shift lever in P and the accelerator pedal not depressed, the condition is judged as normal.
    • [*1] to [*5]: Normal judgment procedure.

      The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

11. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
12. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.