Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
Performing the check procedures for a long time with shift lever in N may cause DTC P3000-00 to be set.
HINT:
- If the battery voltage sensor has been replaced, it is necessary to confirm the voltage of each battery block. With ignition switch ON (READY), shift lever in P, the engine stopped and the HV battery voltage at 224 V or more, check the value of Data List items "Hybrid Battery Voltage", "VL-Voltage before Boosting" and "VH-Voltage after Boosting". When the system is normal, the values of "Hybrid Battery Voltage", "VL-Voltage before Boosting", and "VH-Voltage after Boosting" should be almost equal. If the difference between each value is more than the voltages specified below, the system is malfunctioning.
Inspection Voltage Maximum Voltage Difference Difference between "Hybrid Battery Voltage" and "VL-Voltage before Boosting" 40 V Difference between "Hybrid Battery Voltage" and "VH-Voltage after Boosting" 47 V Difference between "VL-Voltage before Boosting" and "VH-Voltage after Boosting" 62 V