DTC P062F-46: Generator Control Module (EEPROM Learning Value) Calibration / Parameter Memory Failure [12/2019 - 11/2023]: Procedure

1. Connect the GTS to the DLC3.
2. Turn the power switch on (IG).
3. Turn the GTS on.
4. Enter the following menus: System Select / Health Check.
5. Check for DTCs.

   Result

   Result	Proceed to
   P062F-46 is output from the motor generator control system.	A
   P062F-46 is output from any system other than the motor generator control system.	B

6. Turn the power switch off.

Result: 

A 

REPLACE INVERTER WITH CONVERTER ASSEMBLY. Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023] 

Result: 

B 

GO TO PERFORM DIAGNOSIS FOR RESPECTIVE SYSTEM