DTC P0BE5-12: Drive Motor "A" Phase U Current Sensor Circuit Short to Battery; DTC P0BE5-14: Drive Motor "A" Phase U Current Sensor Circuit Short to Ground or Open; DTC P0BE5-1F: Drive Motor "A" Phase U Current Sensor Circuit Intermittent; DTC P0BE9-12: Drive Motor "A" Phase V Current Sensor Circuit Short to Battery; DTC P0BE9-14: Drive Motor "A" Phase V Current Sensor Circuit Short to Ground or Open; DTC P0BE9-1F: Drive Motor "A" Phase V Current Sensor Circuit Intermittent; DTC P0BED-12: Drive Motor "A" Phase W Current Sensor Circuit Short to Battery; DTC P0BED-14: Drive Motor "A" Phase W Current Sensor Circuit Short to Ground or Open; DTC P0BED-1F: Drive Motor "A" Phase W Current Sensor Circuit Intermittent [12/2019 - 11/2023]: Procedure

1. Check for DTCs.

   Powertrain > Motor Generator > Trouble Codes 

   Result

   Result	Proceed to
   P0BE5-12, P0BE5-14, P0BE5-1F, P0BE9-12, P0BE9-14, P0BE9-1F, P0BED-12, P0BED-14 and P0BED-1F only is output, or DTCs except the ones in the table below are also output.	A
   Any of the following DTCs including pending DTCs are also output.	B

   Malfunction Content	Relevant DTC
   Power source circuit malfunction	P06B0-1C	Generator Control Module Position Sensor REF Power Source Circuit Voltage Out of Range
   	P06D6-1C	Generator Control Module Offset Power Circuit Voltage Out of Range
   System malfunction	P0A78-73	Drive Motor "A" Inverter Actuator Stuck Closed

   HINT: 

   1. P0BE5-12, P0BE5-14, P0BE5-1F, P0BE9-12, P0BE9-14, P0BE9-1F, P0BED-12, P0BED-14 and P0BED-1F may be output as a result of the malfunction indicated by the DTCs above.
      1. The chart above is listed in inspection order of priority.
      2. Check DTCs that are output at the same time by following the listed order. (The main cause of the malfunction can be determined without performing unnecessary inspections.)
2. Turn the ignition switch off.

Result: 

B 

GO TO DTC CHART (MOTOR GENERATOR CONTROL SYSTEM)  . Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2019 - 10/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2021 - 11/2023]

Result: 

A 

See step  2

Refer to PROCEDURE - Step 3

Result

Result: 

A 

REPLACE INVERTER WITH CONVERTER ASSEMBLY 

Refer to REMOVAL [12/2019 - 10/2022] , or refer to REMOVAL [10/2022 - 11/2023]

Result: 

B 

CONNECT SECURELY 

Result: 

C 

REPAIR OR REPLACE HARNESS OR CONNECTOR