DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Lubrication System (A25A-FXS) - Service Information) >> Engine Oil Cooler >> Installation [12/2019 - ] >> Procedure

Installation [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL OIL COOLER ASSEMBLY 
    1. w/ Filter:
      1. Install a new oil control valve filter to the cylinder block sub-assembly.
    2. Install 2 new oil cooler gaskets to the oil cooler assembly.
    3. Install the oil cooler assembly to the cylinder block sub-assembly with the 4 bolts.

      Torque: 16 N.m (163 kgf/cm, 12 ft.lbf) 

    4. Connect the No. 1 water by-pass hose and No. 2 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.
  2. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5 [12/2019 - 10/2021] , or refer to PROCEDURE - Step 5 [10/2021 - 10/2022] , or refer to PROCEDURE - Step 5 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 5 [11/2023 - ]

  3. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 2

  4. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1 [12/2019 - 11/2023] , or refer to PROCEDURE - Step 1 [11/2023 - ]

  5. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6 [12/2019 - 10/2021] , or refer to PROCEDURE - Step 6 [10/2021 - 10/2022] , or refer to PROCEDURE - Step 6 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 6 [11/2023 - ]

  6. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 3

  7. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    See step  6

Diesel-Data.com