DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Lubrication System (A25A-FXS) - Service Information) >> Oil Pressure Switching Valve >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT OIL PRESSURE CONTROL VALVE ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 6.2 to 8.2 Ω

      If the result is not as specified, replace the oil pressure control valve assembly.

      GTY765070Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Oil Pressure Control Valve Assembly)
    2. Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.

      Check that a clicking sound is heard from the oil pressure control valve assembly.

      GTY766945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Oil Pressure Control Valve Assembly)
      NOTE:
      • Check that the battery voltage is between 10 and 16 V before performing this test.
      • Perform this test within 10 seconds to prevent the coil from burning out.
      • Always switch the voltage on and off at the battery side, not the oil pressure control valve assembly side.

      If the result is not as specified, replace the oil pressure control valve assembly.

Diesel-Data.com