Confirmation Driving Pattern

HINT: 

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

  Refer to UTILITY [12/2019 - 11/2023]

• When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.

  Refer to DTC CHECK / CLEAR [12/2019 - 11/2023]

1. Connect the GTS to the DLC3.
2. Turn the ignition switch to ON and turn the GTS on.
3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
4. Turn the ignition switch off and wait for 2 minutes or more.
5. Turn the ignition switch to ON and turn the GTS on.
6. With ignition switch ON and wait for 5 seconds or more.* [*1]

   *: Lightly wiggle the connectors and wire harnesses up and down and right and left.

7. Turn the ignition switch to ON (READY) and wait for 5 seconds or more. [*2]
8. Depress the accelerator pedal of the vehicle with the engine stopped and shift lever in P to start the engine. [*3]
9. Keep the engine running for 5 seconds or more. [*4]
10. Drive the vehicle forward with the shift lever in D for 5 m (16 ft.) or more. [*5]
11. Drive the vehicle backward with the shift lever in R for 5 m (16 ft.) or more. [*6]

    HINT: 

    [*1] to [*6]: Normal judgment procedure.

    The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

12. Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
13. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.