DTC P0A60-12: Drive Motor "A" Phase V Current (High Resolution) Circuit Short to Battery; DTC P0A60-14: Drive Motor "A" Phase V Current (High Resolution) Circuit Short to Ground or Open; DTC P0A60-1C: Drive Motor "A" Phase V Current (High Resolution) Circuit Voltage Out of Range; DTC P0A60-1F: Drive Motor "A" Phase V Current (High Resolution) Circuit Intermittent; DTC P0A63-12: Drive Motor "A" Phase W Current (High Resolution) Circuit Short to Battery; DTC P0A63-14: Drive Motor "A" Phase W Current (High Resolution) Circuit Short to Ground or Open; DTC P0A63-1C: Drive Motor "A" Phase W Current (High Resolution) Circuit Voltage Out of Range; DTC P0A63-1F: Drive Motor "A" Phase W Current (High Resolution) Circuit Intermittent [12/2019 - 11/2023]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (MOTOR GENERATOR)
- Check for DTCs.
Powertrain > Motor Generator > Trouble Codes
Result
Result Proceed to P0A60-12, P0A60-14, P0A60-1C, P0A60-1F, P0A63-12, P0A63-14, P0A63-1C or P0A63-1F only is output, or DTCs except the ones in the table below are also output. A Any of the following DTCs including pending DTCs are also output. B Malfunction Content Relevant DTC Power source circuit malfunction P06B0-1C Generator Control Module Position Sensor REF Power Source Circuit Voltage Out of Range P06D6-1C Generator Control Module Offset Power Circuit Voltage Out of Range System malfunction P0A78-73 Drive Motor "A" Inverter Actuator Stuck Closed HINT:
- P0A60-12, P0A60-14, P0A60-1C, P0A60-1F, P0A63-12, P0A63-14, P0A63-1C or P0A63-1F may be output as a result of the malfunctions indicated by the DTCs above.
- The chart above is listed in inspection order of priority.
- Check DTCs that are output at the same time by following the listed order. (The main cause of the malfunction can be determined without performing unnecessary inspections.)
- P0A60-12, P0A60-14, P0A60-1C, P0A60-1F, P0A63-12, P0A63-14, P0A63-1C or P0A63-1F may be output as a result of the malfunctions indicated by the DTCs above.
- Turn the ignition switch off.
Result:
B
GO TO DTC CHART (MOTOR GENERATOR CONTROL SYSTEM) . Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2019 - 10/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2021 - 11/2023]
Result:
A
See step 2
- Check for DTCs.
- CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR)
See step 3
Result
Result Proceed to OK A NG (The connector is not connected securely.) B NG (The terminals are not making secure contact or are deformed, or water or foreign matter exists in the connector.) C Result:
A
REPLACE INVERTER WITH CONVERTER ASSEMBLY
Refer to REMOVAL [12/2019 - 10/2022] , or refer to REMOVAL [10/2022 - 11/2023]
Result:
B
CONNECT SECURELY
Result:
C
REPAIR OR REPLACE HARNESS OR CONNECTOR