DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Electrical >> Gauges >> HEADUP Display System - Diagnostics - Introduction >> HEADUP Display System >> Data List / Active Test [12/2019 - ] >> Data List / Active Test [12/2019 - ]

Data List / Active Test [12/2019 - ]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the GTS on.
    4. Enter the following menus: Body Electrical / Head Up Display / Data List.
    5. Read the Data List according to the display on the GTS.

      HINT: 

      Depending on the specifications of the vehicle, some items may not be displayed.

      Body Electrical > Head Up Display > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Total Distance Traveled Total driving distance Min.: 0, Max.: 16777215 - -
      Total Distance Traveled - Unit Total driving distance unit km or mile - -
      Main Switch Headup display switch OFF or ON OFF: Headup display off
      ON: Headup display on      		 Not applicable to this vehicle
      +B Voltage Auxiliary battery voltage Min.: 0.0 V, Max.: 25.5 V or Unset 11 to 14 V -
      Illumination Rate from Illuminance Sensor Illuminance input value
      (Meter mirror sub-assembly)      		 Min.: 0 lx, Max.: 65535 lx or Unset Value is output according to ambient light level 0 is displayed when there is no light
      Vehicle Speed Meter Vehicle speed input value Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) or Unset Almost the same as actual vehicle speed -
      Engine RPM Engine speed input value Min.: 0 rpm, Max.: 12701 rpm or Unset Almost the same as actual tachometer -
      Brightness Up Switch Brightness up switch status at brightness setting OFF or ON OFF: Switch not pressed
      ON: Switch pressed      		 -
      Brightness Down Switch Brightness down switch status at brightness setting OFF or ON OFF: Switch not pressed
      ON: Switch pressed      		 -
      Projection Position Up Switch Display position up switch status at display position setting OFF or ON OFF: Switch not pressed
      ON: Switch pressed      		 -
      Projection Position Down Switch Display position down switch status at display position setting OFF or ON OFF: Switch not pressed
      ON: Switch pressed      		 -
      Display Change Switch Headup display switch OFF or ON OFF: Headup display off
      ON: Headup display on      		 -
      Display Angle Concave mirror (Meter mirror sub-assembly) angle Min.: -12.7 deg, Max.: 12.8 deg or Unset Current angle of concave mirror in meter mirror sub-assembly As this value increases, the projection position of the headup display moves upward
      Ambient Temperature (Celsius) Outside temperature
      (Celsius)      		 Min.: -40.0°C, Max.: 87.1°C or Unset Almost the same as actual outside temperature -
      Ambient Temperature (Fahrenheit) Outside temperature
      (Fahrenheit)      		 Min.: -40°F, Max.: 215°F or Unset Almost the same as actual outside temperature -
      Illumination Rate from Light Control Sensor Illuminance input value
      (Automatic light control sensor)      		 Min.: 0 lx, Max.: 65535 lx or Unset Value is output according to ambient light level 0 is displayed when there is no light
      LDA System Existence of lane control system Without or With Without: w/o Lane Control System
      With: w/ Lane Control System      		 -
      PCS System Existence of pre-collision system Without or With Without: w/o Pre-collision System
      With: w/ Pre-collision System      		 -
      ICS System Existence of parking support brake system Without or With Without: w/o Parking Support Brake System
      With: w/ Parking Support Brake System      		 -
      Radar Cruise System Existence of dynamic radar cruise control system Without or With Without: w/o Dynamic Radar Cruise Control System
      With: w/ Dynamic Radar Cruise Control System      		 -
      Intuitive P/A System Existence of intuitive parking assist system Without or With Without: w/o Intuitive Parking Assist System
      With: w/ Intuitive Parking Assist System      		 -
      Road Sign Assist System Existence of road sign assist system Without or With Without: w/o Road Sign Assist System
      With: w/ Road Sign Assist System      		 -
      HV System Indicator Hybrid system indicator value Min.: -101%, Max.: 511% or Unset Current hybrid system indicator value "Unset" is displayed when the vehicle is stopped and the ignition switch is ON (READY).
      Navigation System Existence of navigation system Without or With Without: w/o Navigation System
      With: w/ Navigation System      		 -
      Audio Information Display Function Setting of audio system operation status display OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Master Caution Display Function Setting of master warning display OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Speed Limit Display Function Setting of speed limit display OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Turn by Turn Animation Function Setting of route guidance to destination display OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Traffic Sign Recognition Animation Function Setting of traffic sign recognition display OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Memory Call Link Function Setting of headup display memory call link function OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      Seat Switch Link Function Setting of headup display power seat switch link function OFF or ON - If it is possible to customize the setting, the current setting is displayed.
      ECO Drive Indicator Zone Display Function Setting of ECO driving indicator function OFF or ON - If it is possible to customize the setting, the current setting is displayed.
  2. ACTIVE TEST 

    HINT: 

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the GTS to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the GTS on.
    4. Enter the following menus: Body Electrical / Head Up Display / Active Test.
    5. Perform the Active Test according to the display on the GTS.

      Body Electrical > Head Up Display > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Color Test Screen (Black) Headup display
      (Black color)      		 ON -
      Color Test Screen (White) Headup display
      (White color)      		 ON -
      Color Test Screen (Red) Headup display
      (Red color)      		 ON -
      Color Test Screen (Green) Headup display
      (Green color)      		 ON -
      Color Test Screen (Blue) Headup display
      (Blue color)      		 ON -
      Color Test Screen (Color Bars) Headup display
      (Color bars)      		 ON -
      Color Test Screen (Adjustment) Headup display
      (Adjustment screen)      		 ON -
      Display Brightness Headup display
      (Display brightness)      		 0 to 100% -
      Display Position Headup display
      (Display position)      		 Up (+3), Up (+2), Up (+1), Center, Down (-1), Down (-2) or Down (-3) -
Diesel-Data.com