Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Front bumper assembly*	Front television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [11/2023 - ]
Replacement or removal and installation of 2 or more parts: Front television camera assembly, radiator grille sub-assembly or front bumper assembly Rear television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [11/2023 - ]

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Target Adjustment (Triangle Target):

Refer to TARGET ADJUSTMENT (TRIANGLE TARGET) [10/2022 - ]

Target Adjustment (Flat Surface Target):

Refer to TARGET ADJUSTMENT (FLAT SURFACE TARGET) [10/2022 - ]

Driving Adjustment:

Refer to DRIVING ADJUSTMENT [10/2022 - ]