DTC C1000-1C: Control Module Internal Temperature Sensor "A" Circuit Voltage Out of Range; DTC C1005-1C: Control Module Internal Temperature Sensor "B" Circuit Voltage Out of Range; DTC C100A-62: Control Module Internal Temperature Sensor A/B Correlation Signal Compare Failure; DTC C1A93-46: Main Microcomputer in Front Recognition Camera Calibration/Parameter Memory Failure; DTC C1A94-45: Image Processing Microcomputer in Front Recognition Camera Program Memory Failure; DTC C1A94-47: Image Processing Microcomputer in Front Recognition Camera Watchdog/Safety MCU Failure; DTC C1A94-87: Image Processing Microcomputer to Main Microcomputer in Front Recognition Camera Missing Message; DTC C1A95-00: Image Processing Module Malfunction in Front Recognition Camera; DTC C1A96-1C: Power Supply Circuit in Front Recognition Camera Circuit Voltage Out of Range [09/2020 - 11/2023]: Procedure

1. Clear the DTCs.

   Chassis > Front Recognition Camera > Clear DTCs 

2. Turn the ignition switch off.
3. Turn the ignition switch to ON and wait 80 seconds or more.
4. Check for DTCs.

   Chassis > Front Recognition Camera > Trouble Codes 

   OK

   DTCs are not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ] 

Result: 

NG 

See step  2

1. Replace the forward recognition camera with a new one.

   Refer to REMOVAL [09/2020 - 11/2023]

2. Perform forward recognition camera adjustment.

   HINT: 

   Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

   One Time Recognition: Refer to TARGET ADJUSTMENT (ONE TIME RECOGNITION) [09/2020 - ]

   Sequential Recognition: Refer to TARGET ADJUSTMENT (SEQUENTIAL RECOGNITION) [09/2020 - ]

   Driving Adjustment: Refer to DRIVING ADJUSTMENT [09/2020 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END