DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Automatic Transmission System (UA80E) - Service Information (1 Of 2)) >> AIR COOLED OIL COOLER (for Sport Package) >> Removal [09/2020 - 10/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil cooler assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly*
  • Measurement of ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
 Parking Support Brake System Refer to CALIBRATION [12/2019 - 11/2023]
Front television camera view adjustment Panoramic View Monitor System Refer to CALIBRATION [12/2019 - 10/2022]
Replacement or removal and installation of 2 or more parts: 
  • Front television camera assembly, radiator grille sub-assembly or front bumper assembly
  • Rear television camera assembly
  • Side television camera assembly LH or outer rear view mirror assembly LH
  • Side television camera assembly RH or outer rear view mirror assembly RH
 Television camera view adjustment Panoramic View Monitor System Refer to CALIBRATION [12/2019 - 10/2022]

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Diesel-Data.com