DTC B0092-83: Left Side Restraints Sensor 2 Value of Signal Protection Calculation Incorrect [11/2023 - ]: Procedure

Pre-procedure1

1. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

2. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Result	Proceed to
   B0092-83 is output	A
   B0092-83 is not output	B

   Post-procedure1

3. None

Result: 

B 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ] 

Result: 

A 

See step  2

Pre-procedure1

1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.

   Procedure1

3. Check that the connectors are properly connected to the airbag sensor assembly and side No. 2 airbag sensor LH.

   OK

   The connectors are properly connected.

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

NG 

CONNECT CONNECTORS PROPERLY 

Result: 

OK 

See step  3

Pre-procedure1

1. Interchange the side No. 2 airbag sensor LH with RH and connect the connectors to them.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Side No. 2 Airbag Sensor RH
   *2	Airbag Sensor Assembly
   *3	Wire Harness

2. Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
3. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

4. Clear the DTCs stored in memory.

   Body Electrical > SRS Airbag > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

5. Turn the ignition switch off.

Result: 

NEXT 

See step  4

Pre-procedure1

1. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

2. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Result	Proceed to
   B0092-83 is output	A
   B0097-83 is output	B
   B0092-83 and B0097-83 are not output	C

   HINT: 

   Codes other than DTCs B0092-83 and B0097-83 may be output at this time, but they are not related to this check.

   Post-procedure1

3. Turn the ignition switch off.
4. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
5. Return the side No. 2 airbag sensor RH and LH to their original positions and connect the connectors to them.

Result: 

A 

REPLACE AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL [11/2023 - ] 

Result: 

B 

REPLACE SIDE NO. 2 AIRBAG SENSOR LH. Refer to  REMOVAL [11/2023 - ] 

Result: 

C 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ]